Galen
New Member
- Posts
- 276
- Location
- Staffordshireshire
Can I fit a D1 front prop on a D2 TD5?
D1 and D2 front props the same size?
- Thread starter Galen
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
If you can fabricate and weld .................... yes
Galen
New Member
- Posts
- 276
- Location
- Staffordshireshire
Damn.
I was hoping to swap one in to eliminate my front prop as the cause of vibration that i'm getting.
I was hoping to swap one in to eliminate my front prop as the cause of vibration that i'm getting.
MartinK
New Member
- Posts
- 433
- Location
- Edinburgh & Aviemore
Had mine off yesterday. Was going to replace the Hookes joint with greasable bearings.
The UJ bearings are part TVC100010
the replacement fastenings (recommended to replace them if you remove them) are Bolt's- 509045 Nut's- NZ606041L
The tightening torque is 47nm, and I stripped one before I got anywhere near 47nm, so now ordered the new fastenings (which I should have done in the first place I guess).
It's not as bad as I expected. At least it was a nice (if cold) day to do it!
Good write-up here www.discovery2.co.uk / Workshop :- front and Rear propshaft
You can buy a whole new D2 propshaft assembly for about £160, complete with greasable UJ's on the hookes joint...
The UJ bearings are part TVC100010
the replacement fastenings (recommended to replace them if you remove them) are Bolt's- 509045 Nut's- NZ606041L
The tightening torque is 47nm, and I stripped one before I got anywhere near 47nm, so now ordered the new fastenings (which I should have done in the first place I guess).
It's not as bad as I expected. At least it was a nice (if cold) day to do it!
Good write-up here www.discovery2.co.uk / Workshop :- front and Rear propshaft
You can buy a whole new D2 propshaft assembly for about £160, complete with greasable UJ's on the hookes joint...
