Could someone tell me how to remove the vents on a 110 TDi??? I suspect my leak in the footwell stems from a dodgy seal. Hence I plan to replace both seals. However, I am struggling to remove the vents! Do the vent knobs screw off allowing vent removal or is there another way to remove them???
Removing vents???
- Thread starter stingrey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
unscrew lever from vent back, remove pin on front of vent
LeadFarmer
Well-Known Member
- Posts
- 6,661
- Location
- Yorkshure
Fully open the vent and then from the outside if you look under the vent you will see two bolts holding it on. Remove these bolts. Then, the only things holding each vent to the body are two split pins. Pinch the open ends together with pliers, then carefully tap them out with a flat screwdriver under the pins head.
Its easy to slip and scratch the bulkhead with the screwdriver, so wrap some tape around the end of the screwdriver to protect the paintwork. Or use a piece of wood instread.
The vent knobs remain in place. If you ever need to remove them (as I did last week) you need to partially remove some of the dashboard. The vent knobs ara also held on with two bolts. Not a difficult job, but getting the grey dashboard part in and out can be tricky.
Its easy to slip and scratch the bulkhead with the screwdriver, so wrap some tape around the end of the screwdriver to protect the paintwork. Or use a piece of wood instread.
The vent knobs remain in place. If you ever need to remove them (as I did last week) you need to partially remove some of the dashboard. The vent knobs ara also held on with two bolts. Not a difficult job, but getting the grey dashboard part in and out can be tricky.
Last edited:
MrJC
Well-Known Member
- Posts
- 1,241
Just what I wanted to know and a very good description... search and ye shall find 
