Neelsfromsa
New Member
- Posts
- 9
Freelander 1 td4 2.0l hse 2007 ran well but now it tuns over but won't start.
Freelander 1 No start
- Thread starter Neelsfromsa
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Arctic2
Well-Known Member
- Posts
- 2,454
- Location
- Westmidlands
Try a leak back test, or check the HPFP regulator O-rings, maybe first try a little engine start spray into the EGR while turning the car over see if it runs or cuts out, only ever use a quick sniff and never keep repeating.
The above can be done with a diagnostic tool which is what you need to do really, otherwise you are hoping
Neelsfromsa
New Member
- Posts
- 9
Thank you. I will try and come back to you.
Messerschmitt
Well-Known Member
- Posts
- 139
- Location
- Rivne, Ukraine
Check the battery during start-up or borrow it from someone is working (or connect to a starter-charger) and try to start from it. Diesel does not need 10 frail revolutions. one is enough but powerful.
Neelsfromsa
New Member
- Posts
- 9
Attachments
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
That's your problem.
Make sure the bits aren't stuck in the pump.
Make sure the bits aren't stuck in the pump.
Neelsfromsa
New Member
- Posts
- 9
Arctic2
Well-Known Member
- Posts
- 2,454
- Location
- Westmidlands
All you can do is check where the regulator pushes into the HPFP wipe it out with a small clean rag with a bit of diesel on it. hopefully you purchased the O-ring set with the large black O-ring which a lot do not and add the extra seal.
This one is a split one so don't make the mistake thinking nit is damaged when you open the new set of O-rings, you will need to twist it a little to get it on.
As above make sure you fit this seal, smear with a little diesel to lubricate before fitting.
But you have found your problem i would say
Neelsfromsa
New Member
- Posts
- 9
All you can do is check where the regulator pushes into the HPFP wipe it out with a small clean rag with a bit of diesel on it. hopefully you purchased the O-ring set with the large black O-ring which a lot do not and add the extra seal.
1
This one is a split one so don't make the mistake thinking nit is damaged when you open the new set of O-rings, you will need to twist it a little to get it on.
2
As above make sure you fit this seal, smear with a little diesel to lubricate before fitting.
3
4
But you have found your problem i would say
Neelsfromsa
New Member
- Posts
- 9
Thank you very much. You helped me a lot........ You are the best
Arctic2
Well-Known Member
- Posts
- 2,454
- Location
- Westmidlands
No problem link below if you have not already purchased the seals.
Fiat Ducato Common Rail Diesel Pump Pressure Regulator seal kit Bosch x 1 | eBay
Fiat Ducato 2.8 JTD. 1 x New Seal Kit for CP1 Common Rail Pump Fuel Regulator. Fiat: Brava - Doblo - Multipla - Palio - Punto (1.9JTD 2000 - 2003). Fits 0 281 002 500 Regulator also 0 281 002 241. Peugeot: 206 - 306 - 307 - 406 - 806 - Expert - Partner (2.0 HDi 1999 - 2007).
www.ebay.co.uk
