xr600
New Member
- Posts
- 23
- Location
- east yorks
afternoon all.i know this subject has been covered more than a few hundred times but.....about a month ago i got the dreaded 3 amigos so i follow the usual route and change brake switch first ,still there ,then nearside sensor as i had changed the drive shaft and thought i might have disturbed sensor so seemed a good place to start,but still there.i decided to check reluctor ring so pulled drive shaft out of hub and the reluctor ring was loose on the shaft and i could spin it round the shaft!i could have sworn these are shrink fitted on,strange ,its almost like it had stretched.anyway the only way i could stop it spinning was to tack it to the shaft with minute blobs of weld and file flush,i put back together and hey presto all lights go out,so if your at your wits end with the 3 amigos check yer rings not loose you know you want to, mark
