Fed up with wipers

In 18 months, I'm on my second pair of wiper blades.
Bleeding junk.
The rubbers are splitting again. In a panic this morning I ordered a two foot length of blade to replace the two thinking it might last a bit longer but for a couple of quid I doubt it very much.
Any thoughts?

Just bought some Allmakes 4x4 wipers - turned out they supply Iguana wipers. A change from Britpart so let's see how they last.

Careful l when the rubber splits, you can end us with kids...

It must have been a conscious decision, honest, but on a second look the ones I have ordered are silicone. Just hope I can get them in the bendy sticky on bits.

Get some bosch ones they always last well

halfords own are much better than you may think and price aint too bad

chrisstdt said:

Get some bosch ones they always last well

Click to expand...

+1, have reverted to Bosch wipers, did this about 5 years ago, they do last much longer.

Move to the east, it don't rain

I fitted these about 5 years ago, they do a much better job of cleaning the screen and they're still going strong.
http://www.wiperblades.co.uk/land-r...wbtr-13-retrofit-aero-twin-pack-wiper-blades/

Arrived a few days ago. Just one at 24 inches but as I need two at 10 inch it seemed a good idea.
First light rain today and they work ok. Lets see how long they last. For two quid including postage anything past January will be a result.

Bobsticle said:

In 18 months, I'm on my second pair of wiper blades.
Bleeding junk.
The rubbers are splitting again. In a panic this morning I ordered a two foot length of blade to replace the two thinking it might last a bit longer but for a couple of quid I doubt it very much.
Any thoughts?

Click to expand...

Same here, but I have feeling some tyke is swapping their shite ones for my noo ones...

as after a week they're rubbish again ...

Dippypud said:

Same here, but I have feeling some tyke is swapping their shite ones for my noo ones...

as after a week they're rubbish again ...

Click to expand...

Its the future for £1.99................. , Not too hard to fit, reusing the thin steel supports that run down the originals. I just bent the tabs out and squoze them back in on the new one.

Bobsticle said:

Its the future for £1.99................. , Not too hard to fit, reusing the thin steel supports that run down the originals. I just bent the tabs out and squoze them back in on the new one.

Click to expand...

Might have a bash at them ...