1961 Series 2A SWB tub floor?

Hi, I just bought a nice series 2A, the floor was knackered in the back, and the previous owner replaced it with a peice of plywood.

Is there anywhere which sells replacement floor panels for these?

So how easy would it be to swap one from another tub?

I got a panel cut to size cost about £45 for the correct birmabright 2mm sheet, bought nw sfiffeners and crossmembers, if you want to replace your own PM me your email and i will send you some info

Hi Steve, thanks for replying.

Do the original tub floors have a shape pressed into them?

Just wondering.

The original is flat on top, but with the top hat channel spot welded on underneath, on mine i got the sides folded up about 30mm as the lips on the wheel arch sections were a bit rotten. the channel on mine was bonded as the local fabricator couldnt spot weld it without burning holes, only cutting i had to do was drill slots /tin snip out near the door and drill pop rivets.

Thanks for the info mate, are the wheel arches made of the same material. It would probably be easier for me to replace those at the same time.