I am confused. From earlier posts I understood that the new parallel kit would not be wired to the ballast resistor as per older pigtail ones but to the thick brown/red input wire, effectively by passing the resistor with 12 v going to the...
1980 Series 3 diesel
After deciding to fit a parallel glow plug setup I tried to remove the old glow plugs. Two came out easily (1 and 2) but the other pair (3 and 4) seem to be welded in place. I thought they were going to snap. Both were caked...
Needing to replace the rear axle seal on my Series 3 1980 I found amongst 30 odd different seals 4 of the above.
I am not going to use them but would like to know what they are for since no searches on line come up with anything.
Just curious...